Filter
Top Products
You observe that Possible Causes What should you do?
The display shows a series of digits and
symbols on first connection
Working normally
Nothing, the hob will be ready to use
within approximately 30 seconds
Installation blows a fuse or
only one side of the hob works
The electrical connection of the hob
is incorrect
Check that it is set up properly (see the
Electrical Connection section)
The hob produces an odour during the
first cooking sessions
New appliance
Heat a saucepan full of water on each
cooking zone for 30 minutes
9 fast frying steaks
Troubleshooting
On first use
IMPORTANT - PLEASE NOTE: In the event of any breakage, crack or cracking – even minimal – of the vitroceramic glass, immedi-
ately disconnect your appliance to prevent a risk of electric shock and contact CDA Customer Care.
In use
You observe that Possible Causes What should you do?
The hob has stopped operating. The
hob beeps at approximately ten second
intervals and a or F7 is displayed on
the zone display
There was an overflow or an object is in
contact with the control panel
Clean the hob or remove the object, and
begin cooking again
A series of small or F7 is displayed The electronic boards heated up See the Installation section
After turning on a zone, the indicator
lights on the control panel continue to
flash
The cookware used is not suitable
for induction or is less than 12 cm in
diameter (10 cm on the 16 cm zone)
See the section on cookware for
induction
The saucepans make noise
during cooking or your hob makes a
clicking sound during cooking
This is normal with some types of
cookware. This is caused by the transfer
of energy from the hob to the cookware
Nothing. There is no risk, neither to your
hob nor to your cookware
The fan continues to function for a few
minutes after the hob is turned off
Cooling of the electronic components.
Working normally
Nothing.
9 fast frying steaks
You observe that Possible Causes What should you do?
The hob does not work and the lights on
the control panel do not switch on
The hob is not connected to the power
supply or the power supply is faulty
Check the electrical circuit breaker and
fuses
The hob is not working and the display
shows a non-standard graphic
The electronics are not functioning
correctly
Call CDA Customer Care
The hob is not working and the display
shows
The childlock is on
Switch off the childlock before trying to
use the hob.
9 fast frying steaks
On switching on