CDA HVN 32 Cooktop User Manual


 
11
Booster Function Rear Cooking Zone Only
This function allows the cooking zone to operate at the
Booster maximum power (above the nominal power) for
maximum 10 minutes; it could be used, for example, to
rapidly heat up large amount of water.
This function is available for the rear cooking zone
only.
To activate the Booster function, the touch control must
be switched ON (see section “
How to Turn the Touch
Control ON and OFF
”).
With the zone at any power level ( 0...9 ), just touch the
key until the rear zone display shows "P".
At the end of the Booster program (10 minutes) the rear
zone is automatically set to the power level " 9 ".
With the zone at the Booster level:
– if touching again the key
- a beep sounds, the heat
up program is cancelled and the power level set to " 9 ";
– if touching the key - an error beep sounds but none
change is performed;
– if touching the key - a beep sounds, the heat up
program is cancelled and the power level set to " 9 ".
Induction Heaters Power Management
The maximum power of the cooktop is limited to 3600 W.
This means that the electronic interface automatically
manages the power levels of the heaters in order to not
exceed the maximum power limit (see also table on the
previous page).
– Both the zones can be used, at the same time, from
power levels "
1 " to " 9 ";
– With the front zone set to power level "
7 ", " 8 "
or " 9 ", if setting the Booster program on the rear
zone the power level of the front zone is automatically
reduced to " 6 ".
– With the Booster program set on the rear zone, if
setting the power level "
7 ", " 8 " or " 9 " on the front
zone the power level of the rear zone is automatically
reduced to " 9 ".