CDA SV150 Oven User Manual


 
21
A
U
T
O
A
U
T
O
Automatic Oven Cooking
To cook food automatically in the oven, it is necessary to:
1. Set the length of the cooking time
2. Set the end of the cooking time
3. Set the temperature and the oven cooking program.
These operations are done in the following way:
1. Set the length of the cooking period by pushing the
button and the button to increase, or to
decrease if you have passed the desired time (fig. 11). The AUTO and the symbol will illuminate.
2. Set the end of the cooking time by pressing the
button (the cooking time already added to the
clock time will appear), and the button (fig. 12); if you pass the desired time you may get back by
pushing the button.
After this setting, the symbol will disappear. If after this setting, the AUTO flashes on the display
and a buzzer sounds, it means there was an error in the programming, that is that the cooking cycle has
been superimposed on the clock. In this case, modify the end of cooking time or the cooking period
itself by following again the above mentioned instructions.
3. Set the temperature and the cooking program by using the switch and thermostat knobs of the oven
(see specific chapters).
Now the oven is programmed and every thing will work automatically, that is the oven will turn on at the
right moment to end the cooking at the established hour.
During cooking, the
symbol remains illuminated.
By pushing the button you can see the time that remains until the end of cooking.
The cooking program may be cancelled at any time by pushing
.
At the end of the cooking time the oven will turn off automatically, the
symbol will turn off, AUTO
will flash and a buz zer will be sound, which can be turned off by pushing any of the but tons except the
/ buttons.
Turn the switch and thermostat knobs to zero and put the programmer onto “manual” by pressing the
button.
Attention: After a power cut the clock resets to zero and cancels the set programs. After a power cut,
three zeros will flash on the display.
Fig. 11 Fig. 12