Filter
Top Products
3
B
Place lower back panel between side panels at rear of bottom shelf. Secure lower back panel to side panels using two
Attach light adapter to back panel using four #8-32x3/8” screws, 4mm lock washers and #8 nuts, shown B.
1/4-20x1/2” screws and 7mm lock washers on left side, shown A.
#8 Nut
Adapter
#8-32x3/8”
4mm lock
screw
washer
A
Lower back panel
1/4-20x1/2”
screw
lock washer
7mm
Insert temperature gauge stem into the biger hole above knob as shown.
Make sure the gauge is pushed in as far as it will go, then push the gauge downward until it clips into the panel, as
shown in C/D.
Temperature gauge stem
Control panel
D
C
Back of the panel
Temperature gauge
25