Filter
Top Products
9
Attach cart partition panel to bottom shelf using two 1/4-20x1/2” screws and 7mm lock washers, shown B.
Attach cart partition panel to lower back panel using two #8x3/8” self-tapping screws, shown C.
Attach cart partition panel to front brace using one #8x3/8” self-tapping screw, shown D.
A
D
B
Insert cart partition panel under control panel between side panels, shown A.
Cart partition
panel
1/4-20x1/2”
screw
7mm lock washer
C
Cart partition panel
Front brace
#8x3/8”
self-tapping screw
#8x3/8”
self-tapping screw
8
Inside of cart, insert rear shield tabs into slots next to grease tray opening on upper back panel, shown A.
Attach front shield tabs(with holes) under front brace with two #8x3/8” self-tapping screws, shown B.
Tank heat shield
Cart lower back panel
Front Brace
#8x3/8”
self-tapping screw
for clarity of illustration
Note: some parts omitted
B
Upper back panel
Grease tray opening
A
28