Filter
Top Products
10
Connect each of the wires from the main burner electrodes into the back of the Electronic Ignition Module.
Total (4) connections, shown A.
Connect the two wires [(a) and (b)] from
the switch wiring harness into the back
of the Electronic Ignition Module.
NOTE: Switch
terminals are larger than electrode
terminals and should only be
installed in location shown as (a),(b).
Total (2) connections, shown A.
ignition module
Electronic
Cart partition
panel
B
C
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart partition panel with
the nut, shown B
Insert AA battery into ignition module, negative (
-) end first. Then put on the cap, shown C.
Nut
-
+
AA battery
Cap
3
1
2
4
(a)
(b)
ignition module
Electronic
A
11
Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of
door, and release hinge pin into door.
Left door
Hinge pin
on bottom
of door
Top of
door
PRESS
Right door
29