Filter
Top Products
65
Do not use the unit on a surface tilted more than 12 degrees (5.6") as it may result in malfunction. Set
up the unit in a location that does not interfere with driving. Secure the unit to prevent shifting or tipping.
Press and hold the On/Off button until you
hear a high-pitched tone and the power
indicator lights up (about one second).
The COOL-1 temperature light will flash
and the unit will begin operating.
Using the ProductUsing the Product
1. Set the unit on a flat, solid surface with the lid facing up.
2. If in vehicle, start the engine.
3. Insert the DC plug into the DC power socket of the cooler.
4. If used in a vehicle, insert the DC
cable power plug into the cigar-
ette lighter or accessory socket.
5. If used indoors, use the house-
hold power supply provided.
6. Press the power button .
7. Press and hold the temperature setting button for approximately one
second to set the desired temperature (refer to page 3 for each setting).
Caution
• The DC power cable has a (+) and (-).
●
Insert the power plug as far as it will go.
●
Keep the socket clean. A dirty socket will cause poor electrical contact, resulting in
reduced performance.
●
Do not use a socket splitter or extension cable. The voltage will drop and the unit may stop working.
●
After turning the power off, the temperature setting will remain in memory for up to 4 hrs. If
the power remains off for an extended period of time, the setting will return to COOL-1 when
switched on again. Always verify the temperature setting when turning on.
●
Condensation may form on the outside of the unit depending on the environment it is being
used in. This may cause corrosion, so wipe away condensation as quickly as possible.
Condensation is a natural phenomenon, and is not a sign of malfunction.
Protrusion
DC socket
Indentation
DC power
cable
On Flashing
Flashing
On
Example: To set the temperature to 43˚F (6˚C) When the temperature reaches approximately
43˚F (6˚C), the light will stay illuminated.
Press and hold COOL-2 for about 1 second.
The unit will not operate at 24 VDC.
Caution
Tips
Note:
Align the protrusion of the DC socket with the indentation in the DC power
cable and insert. Inserting the top and bottom in reverse will cause damage.
• Always check the "on/off" switch to make sure it is in desired status
after extended low voltage or power interuption.
The unit will shut off automatically to protect the battery under
conditions such as extended car engine cranking.
• Be careful of the current capacity.
When using this product together with other electrical products in the
vehicle, do not exceed the capacity of the vehicle. A fuse may blow.
• This unit cannot be used in 24 VDC vehicles (trucks, buses, etc.).
It is designed for 12 VDC only. Attaching it to a 24 VDC source will cause damage.
• Use only the power cable and power supply supplied with your cooler.
If you need replacements, contact The Coleman Company, Inc. for replace-
ments by calling one of the numbers on the front cover of this manual.
5.6"
max tilt