Filter
Top Products
10
To Light
NOTE: A gap of 1/8” should be maintained between the end
of the wire on the electrode and the burner tube for proper
ignition spark. (Fig. 15)
1.
Set on sturdy, flat surface.
2.
Grasp end of wire with a needle nose pliers and carefully bend
to adjust to proper spacing from burner tube (Fig. 15). Be
careful to not break or crack the ceramic insulator.
To Adjust Igniter
Fig. 15
1/8” Gap
CAUTION
Use a long wooden match or a match extension
To Match Light
1.
Set on sturdy, flat surface. For outdoor use only.
2.
Hold a lighted match near the burner, then turn regulator knob
and rotate clockwise.
(Fig. 16)
3.
Adjust flame with control valve. (Fig. 17)
To Light
continued
INSTASTART™ Electronic Ignition Grills (continued)
3.
If igniter still fails to light grill, use match to light burner or check
for proper gap between igniter wire and burner tube. (See
Fig. 15)
4.
Adjust flame with regulator valve. (Fig. 14)
Fig. 14
Fig. 16
Fig. 17