Filter
Top Products
FIGURE 4
OPTIONAL
ELECTRIC CONDENSATE EVAPORA
TOR INSTALLATION
REMOVAL OF DOORS AND DOOR ADJUSTMENT
During installation, it may become necessary to remove the cabinet doors to facilitate
passage through narrow doorways or hallways. To remove a door, swing the door to
the open-door position (90°) and remove the two screws marked “a” (figure 5) while
carefully holding the door open. Care must be taken to hold the door fully open during
the screw removal since the top hinge is spring loaded and may snap towards the door
when the screws are removed. After removing both screws, carefully lift the door
straight upward to avoid bending the bottom hinge pin. To reinstall the door, reverse
the above procedure.
Caution: The top hinge is spring loaded and may snap towards the door when
the mounting screws are removed. Be sure to hold door fully open before
removing mounting screws.
All doors have been aligned at the factory, however vibration during transportation
may cause doors to shift and realignment may be necessary. If the door(s) require
realignment, proceed as follows:
1. Swing the door to the open-door position and loosen but do not remove
the screws marked “A” on both top and bottom hinges (see figure 5).
2. Relocate the door to its required position by hand or by tapping on the
door edges with a hammer and a block of wood.
3. Securely tighten all screws “A”.
10