Filter
Top Products
Important Note: To assure maximum operating efficiency, your new “SW” series
model should be located where an unrestricted air supply can circulate underneath
and behind the cabinet. For optimum performance, the cabinet must be installed on
legs or casters (see “installing legs or installing casters” later in this section) and a min-
imum of 3" on each side and rear of the cabinet must be provided (see figure 1a). Your
model has been designed to operate sufficiently without legs or casters and directly on
the floor as long as a minimum clearance of 8" is provided from the rear venting lou-
vers and the rear wall (see figure 1b). Cabinet side clearance is not required when
mounting your model directly on the floor without legs or casters. If
necessary, special venting or air supply ducts must be installed by the installer if
any of the above conditions cannot be achieved. Do not at any time obstruct the
grill area in the rear of the cabinet in any way, and never place or store anything
inside of the cabinet machine compartment. These rules are essential for maximum
cooling capacity and long life of refrigeration parts.
5
FIGURE 1a
MINIMUM CLEARANCE DIMENSIONS FOR OPTIMUM CONDITIONS