Filter
Top Products
REMOVAL AND REPLACEMENT OF HINGE MECHANISM
To remove the hinge mechanism from the door, remove the door from the cabinet
as explained above. As shown in figure 6, remove the hinge plate from the hinge
mechanism by removing the hinge pin screw. Also remove the horseshoe spring.
Reinstall the hinge pin screw only partially leaving about
1
/8" of exposed screw
threads. Now, the hinge mechanism mounting screws can be removed thus
allowing the mechanism to be removed by pulling on the hinge pin screw. If the
mechanism does not readily slide out of the door, slide a claw hammer or forked
prybar under the hinge pin screw head and using a block of wood for leverage,
lift the entire mechanism out of the door. To install the new hinge mechanism,
reverse the above procedure.
INITIAL CLEANING PROCEDURE
Prior to start-up and before placing any food inside of your new model, the interior
of the cabinet should be thoroughly cleaned. Washing with a mild soap and warm
water solution is recommended for cleaning the aluminum and stainless steel
surfaces of your cabinet. This should be followed by cleaning with a baking soda
solution (three (3) tablespoons of baking soda to each quart of warm water).
Rinse thoroughly with clear water and dry with a clean, soft cloth.
12