Filter
Top Products
Deli Shop Model 436 Setup Guide
4360001 15
4
5
9
0
C
FD
427P0014
Faults
Display all the active faults on your merchandiser:
1. Press the MODE switch on the main controller.
2. Press until the display shows . Note: If no faults are present, this will not be displayed.
3. If errors are present, press to see the list of faults:
When the first fault item (if any) repeats, you have seen all the faults.
4. Press to see more faults or to exit.
The EPROM is bad.
RAM is not initialized or is not compatible with the currently loaded software. If
this message appears, initialize your RAM by performing the following procedure:
NOTE: Initializing RAM will erase all your data. Be sure you have written this
information down before continuing.
Press AND HOLD . You will see in the display. Continue holding until the
display shows .
...XX
The health control has been set. "XX°F" is the maximum temperature reached.
.
The temperature reference on the main PCB cannot be read.
.
The temperature sensor cannot be read.
.
The temperature sensor is out of range.
.
Problem with the bill validator.
.
Problem with the card reader.
.
Problem with the coin mechanism.
...
All selections are out of service.
.
Illegal price is detected. Clear by checking prices.
.
Cannot read switch inputs. Disconnect J58 at the main controller and scroll through
the error list. If the error persists, replace the main controller. Otherwise, check the
switch harnesses.
. X
Did not read the vend door lock switch when door solenoid X was energized.