Filter
Top Products
Before calling a Service Engineer, please check through the following lists.
THERE MAY BE NOTHING WRONG.
Something Wrong?
Problem
Nothing works.
Display shows 0.00 AUTO.
Fan oven does not work but the
grill works.
Fan Oven and Grill do not work.
Grill does not work.
Grill keeps turning on and off.
Can not set an “Auto Cook”
programme
Draught from beneath control
panel.
Timer buzzer/bleeper operates
continually
Check
(a) Check
If you find :-
Display is blank.
Then it is likely that there is no electricity supply to your oven.
Check: (i) That the main cooker wall switch is turned on.
(ii) Check other appliances to see if you have a power cut.
(iii) Check the main circuit breaker for the property.
(iv) With oven selected, the oven light does not illuminate.
The power supply to your oven has possibly been interrupted, but has
now come back on again. Reset the timer to the correct time of day
and "Manual" operation using instructions given in the timer section
of the book.
Check to ensure that the timer is in Manual Mode:
See timer section for instructions on how to return timer to
"Manual".
Operating the cooker under the following conditions may cause a
safety device to operate.
(a) Grilling with the door closed - always grill with the door open to
the correct position - see grilling.
(b) Grilling for an excessively long period at maximum setting -
see grilling guide.
(c) Grilling with inadequate ventilation in the cabinet - see
installation instructions.
Check that you have selected :- "Grill" function on the "Fan oven/Grill
Select" knob (A) and
a Grill setting on the Grill Knob (B) - see grilling
page.
When the Grill control (B) is operating at less than "6", the grill will
cycle on and off, this is normal and is not a fault.
Remember: "Cook Period" is the actual length of time for which, the
timer will switch the oven on as part of an "Auto Cooking"
programme.
A gentle flow of air will be blown from beneath the control panel
when the appliance is used. If the appliance is still warm, this cooling
fan may run on, or restart itself after all of the controls have been
turned off.
The fan will stop once the appliance has been cooled. This is normal
and not a fault.
Buzzer/Bleeper should stop automatically after a short time.
If not, press minute minder button to silence.
If you have been through the above list and there is still a problem; You should identify your Service
Agent using the list on the back page and contact your Local Service Office.
35