Filter
Top Products
5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Retherm
Ovens
FL-2273
Rev. 2 (6/08) Page 5 of 11
OPERATING INSTRUCTIONS (continued)
HOW TO OPERATE WITH FOOD:
Manual (Timed mode) Operation
See “HOW TO SET CONTROL” for programming
instructions
Push the power switch to “ON”.
Press the SELECT button and choose the TIMED
mode.
Press the COOK button and set to desired temperature
Press the PROBE/TIME button and set the desired
time.
Press the HOLD button and set the desired
temperature.
Place the food into oven. Close door and double check
cooking time and temperatures. Then press the START
button to start the cooking/retherm cycle and the Cook
LED will light up.
The oven will beep and automatically switch the
HOLD mode at the end of the cooking cycle. The
Cook LED will go out and Hold LED will light up.
1.
2.
3.
4.
5.
6.
7.
PROBE COOKING
See “HOW TO SET CONTROL” for programming
instructions
Push the power switch to “ON”.
Press the SELECT button and choose the Probe mode.
Insert the probe jack into the receptacle located inside
the oven top, near the fans. The probe temperature
display will show the digital temperature of the probe.
Put sanitized probe into center of food product. Make
sure food is in the center of the pan, in the center of
the oven.
Press the start button. The Cook LED will light up and
the display will show the internal temperature of the
food being cooked.
NOTE: Do NOT change the mode of controls (probed or
timed) while oven is operating in a Cook/Retherm cycle.
Oven must be off, or in the HOLD cycle, to change the
timer or probe operation.
HOW TO SET HOLD ONLY MODE:
NOTE: Cold food is NOT to be added when unit is
operating in the HOLD mode.
For HOLD mode, preheat unit to 180°F/82°C for 60
minutes.
Push the power switch to “ON”.
Press the HOLD button and set the desired hold
temperature.
Press the PROBE/TIME button to set it to zero time.
Press the START button and the Hold LED will light
up.
HOW TO SHUT DOWN OVEN:
Push power switch to “OFF”.
CAUTION: Ventilating fans will continue to run until
cabinet is cool. Do NOT disconnect the power supply to
the cabinet while the ventilating fans are still operating, or
damage to components could result.
1.
2.
3.
4.
5.
1.
2.
3.
4.