Filter
Top Products
3. USE OF THE APPLIANCE
A. ASSEMBLY
Before the first use or after an extended period of non-use, fill
the reservoir with cold water up to its maximum level (without
coffee nor filter). Put the coffee pot into position, switch on
( + O/I switch) and let the water flow.
1. Insert the water filter
a. Remove the filter from polybag and soak in cold tap
water for 15 minutes.
b. The water filter holder is located inside the water
reservoir, on the left. Open the lid of the coffeemaker
and remove the water filter holder by lifting it out. To
open the water filter holder, place thumbs in slots directly
under the arrows and pull open in opposite directions.
c. Place the filter at the bottom of the water filter holder as
indicated on the diagram (Filter will only fit correctly in
one end of the holder, that is the right side of the holder
when positioned as on the diagram).
d. Close the water filter holder.
e. Re-place the water filter holder in the water reservoir
pushing it all the way down to the base of the unit (The
side of the holder where the filter is located should be
downwards).
It is advised to replace the filter every 60th use
approximately.
Filter
11
1
2
5
6
7
12
13
10
11
8
9
DCC1200WE-DCC1200E IB 30/11/04 9:49 Page 12