Filter
Top Products
• Don't twist locking ring from
blender jar when removing blender
jar from motor base. Simply lift
blender jar from motor base.
• Don’t overprocess foods. Blender or
food processor will achieve most
desired results in seconds, not minutes.
• Don’t overload blender or food
processor. If the motor stalls, turn
OFF immediately, unplug the unit,
and remove a portion of the food,
then continue.
• Don’t use any utensil inside the
blender jar or food processor bowl
while the motor is ON.
• Don’t use any containers or accessories
not recommended by Cuisinart. Doing
so may result in injury.
• Don’t place hands inside the blender
jar or food processor bowl when
blender is plugged in.
• Don’t add boiling liquids or frozen
foods (except ice cubes or 1/2" pieces
of frozen fruit) to glass blender
jar. Boiling liquids should cool for
5 minutes before being placed in
blender jar.
• The food processor accessory is not
intended to crush ice. This could
damage the chopping blade and will
damage work bowl.
FOOD PROCESSOR
FEATURES
1. Food pusher with oil dispenser
2. Bowl cover with feed tube
3. Sharp stainless steel chopping blade
chops raw and cooked food to any
consistency from coarse chop to
fine purée
4. Stainless steel reversible
slicing/shredding disc makes
perfect slices
5. Adapter stem
6. Clear work bowl
7. Gearbox collar
8. Same motor base used for both the
blender jar and the food processor
bowl
FOOD PROCESSOR
STEP BY STEP:
GETTING STARTED
Please note that the bowl with collar
will fit on the base in eight different
positions. The handle can be in front
or on either side, and the feed tube in
front, back, or on either side.
Directions for use reference a certain
position for instructional purposes
only.
FOOD PROCESSOR ASSEMBLY
FOR CHOPPING, PURÉEING &
MIXING
1. Hold gearbox collar in one hand
and work bowl handle in the other.
Twist bowl clockwise onto collar.
2. Place collar with bowl onto motor
base with handle facing front.
3. Place chopping blade over shaft in
work bowl. Chopping blade should
slide easily to the bottom of the
bowl. Lower blade will almost
touch bottom of bowl.
BE SURE TO HANDLE THE
METAL BLADE WITH CARE,
AS IT IS RAZOR SHARP!
4. Place food to be processed in work
bowl. Put cover on work bowl, with
feed tube at about 11 o’clock. Turn
the cover clockwise until it fits into
position. Cover lock must click
into
locked position prior to use. If you
have trouble fitting the cover on
Food Pusher with Oil Dispenser (1)
Bowl Cover with Feed Tube (2)
Reversible Slicing/
Shredding Disc (4)
Stainless Steel Chopping Blade (3)
Adapter Stem (5)
Work Bowl (6)
Gearbox Collar (7)
Blender Base (8)
6