Filter
Top Products
9
Operating the Oven
GlideRack™ Oven Racks
Your oven comes with Dacor’s deluxe GlideRack oven
racks. You can pull them out further than other types of
oven racks and still support heavy pots and pans full of
food. They are great for heavier foods and the optional
Dacor baking stone.
To install a GlideRack oven rack:
1. Align both sets of safety clips (right and left) on the
back of the rack guides with the oven rack supports as
shown below. NOTE: The diagram below shows instal-
lation with the rack guides extended but, the rack
may be installed with or without the guides extended,
whichever is easier.
2. Begin to slide the rack in, lifting the front safety clips
over the front of the oven rack supports.
3. Push the rack all the way in.
4. Grasp the rack in the center of the front and pull. The
rack should come forward while the guides remain in
place.
To remove a GlideRack oven rack:
• Grasp the rack with both hands and pull it gently
straight out toward you until it stops.
• Lift up until the front safety clips just clear the front
of the rack supports on the oven. Continue to pull out.
Moving the end of the rack back and forth slightly, left
to right, as you pull, will make it easier to remove.
Racks
You may use either rack type on any level inside the oven.
WARNING
To reduce the chance of burns, position the oven
racks when the oven is cool. If you must reposition a
rack when the oven is hot, do not allow potholders to
contact the heating element inside the oven.
Standard Racks
To insert a standard oven rack:
1. Insert the end of the rack with the safety notches into
the oven first.
2. Attach both sides of the rack to the rack supports in
the oven as shown in the diagram below.
3. Begin to slide the rack in, and then, lift up so that the
safety notches clear the ends of the rack supports.
4. Push the rack all the way in with both hands.
To remove a standard oven rack:
• If you want to remove an oven rack, grasp it with
both hands and pull gently straight out toward you
until it stops.
• To remove the rack completely, lift the front of the
rack up about six inches and continue to pull it out.
Lifting the rack releases the safety notches. The
safety notches reduce the chances of a rack coming
out of the oven accidentally.
GlideRack Oven Rack Installation
Standard Rack
Front of
rack
Lift front safety clips
over rack supports
Rack
support
Slide oven rack
supports between
back safety clips
Back of
guide
Rack guides
Front of rack
Safety notch
Rack
support
Slide oven rack
supports into slots
on the rack
Back of rack