Filter
Top Products
13
Raise the door so that it is at a 15° angle from the front 3.
of the oven. Hold the door with one hand on each side.
Lift the door up and out.
Install the Oven in the Cabinet
WARNING
Use an appliance dolly to move the appliance when •
installing it or removing it from the wall for service.
Use of an appliance dolly will minimize the risk of
personal injury as a result of the oven tipping.
Failure to install the mounting screws may result in •
movement or tipping of the oven during use, or per-
sonal injury.
Do not block the oven air exhaust and intake located •
at the bottom of the oven door(s). Blocking the air-
flow may cause cabinet damage and poor baking
performance.
IMPORTANT
An oven that is not level may provide poor or inconsistent
baking results.
Lift the oven up to the cabinet cutout using the handles
1.
and gripping points shown. Use extreme caution when
lifting the appliance, because it is heavy.
Installation Instructions
Support the oven at all times until it is secured into the 2.
cabinet. Be certain to take all necessary safety precau-
tions.
Resting the oven on the cabinet support platform, slide
3.
the oven into the recessed area until the rear edge of
the oven trim post is flush with the cabinet face and
the oven is centered within the cutout. Ensure that
the electrical conduit slides through the opening in the
cabinet platform or coils above the oven chassis as the
oven is slid into place. Do not trap the appliance cable
between the oven case back and the rear wall.
Make sure the oven is resting level. Shim it if neces-
4.
sary.
WARNING
When installing the mounting screws into composite
cabinets, install them into the sides of the cabinet only.
Mounting screws installed into the front of composite
cabinets will have a tendency to pull loose.
Find the mounting hole locations in the front and side
5.
of the oven trim posts. Drill 1/16” pilot holes in the cabi-
net through the front or side of the trim posts. Single
oven models require four (4) holes, while double oven
models require six (6).
Install the #6 x 3/4” screws provided in the instructions
6.
envelope. Do not over-tighten.
Trim Post
Trim Post
Gripping Point
Gripping Point
Gripping Point
Handle
Door Gripping
Points