Filter
Top Products
9
Installation Instructions
Electrical Connection
WARNING
If the electrical service provided does not meet the •
Product Specifications (see page 4), do not proceed
with the installation. Call a licensed electrician to cor-
rectly install the required wiring.
Failure to disconnect power prior to installation may •
result in an electrical shock or fire hazard.
Do not turn on power to the appliance until the oven is •
properly grounded according to these instructions.
The installer must connect the ground terminal (or •
lead) on the appliance to a grounded, metallic, perma-
nent wiring system or grounding conductor. Failure to
do so may result in an electric shock hazard.
Do not use an extension cord with this appliance. Such •
use may result in fire, electric shock or personal injury.
Do not install a fuse in the neutral or ground circuit. A •
fuse in the neutral or ground circuit may result in an
electric shock hazard.
The appliance must be connected to the power supply •
with copper wire only. The use of aluminum wire may
result in unsatisfactory conditions.
IMPORTANT
Provide slack in the conduit to allow the oven to slide for-
ward for servicing.
NOTE
The electrical connection leads from the supplied appli-
ance conduit may be a smaller gage than the standard
household wiring of the dedicated supply circuit. They
are suitable for connection to household wiring under the
jurisdiction of the National Electric Code, and/or the local
inspection authority.
Before proceeding, turn off power to the circuit to which 1.
the oven will be connected at the circuit breaker or fuse
box.
Position the oven directly in front of the cabinet cut out.2.
Feed the appliance conduit into the electrical junction 3.
box and attach it using a UL approved strain relief.
Depending upon local codes, utilize one of three meth-4.
ods to connect the appliance to the electrical power:
Connect to a four wire electrical system◊
Connect to a three wire electrical system, where ◊
local codes permit
Connect to a three wire electrical system with ◊
external ground, according to local codes.
See the instructions below and on the following pages for
detailed instructions.
Connecting to a Four Wire Electrical
System
Separate the wires coming out of the appliance conduit.1.
Connect the white wire from the appliance conduit to 2.
the white (neutral) supply wire in the junction box.
Connect the black wire from the appliance conduit to 3.
the black (L1) supply wire in the junction box.
Connect the red wire from the appliance conduit to the 4.
red (L2) supply wire in the junction box.
Connect the green wire from the appliance conduit to 5.
the green (ground) wire in the junction box.
Incoming power
Wire nut,
4 places
Junction box
Conduit to
oven
Four Wire Connection