Filter
Top Products
CLEANING THE BURNERS:
For proper lighting and performance keep the burners clean. It is necessary to clean the burners if they
do not light although the igniter clicks, whenever there has been a severe boil over or when the flame
doesn’t burn blue.
Be certain all burner knobs are in the
OFF position
before attempting to clean the burners.The burners
have been designed for ease of cleaning.When the
grates and burners are cool, remove the grate.The
Burner Cap and the Brass Port Ring can easily be
lifted off.Wash these parts in hot soapy water, rinse
and dry thoroughly.The Burner Caps are porcelain
enamel, follow the directions on page 9 that were
given to clean the burner grates.A bristle brush can
be used to clean out the toothed burner ports, if
necessary. Disassembly of the Simmer Ring is not
recommended, however, it may become necessary to
do so if the ports remain clogged after normal
cleaning. If it is necessary to disassemble the Simmer
Ring from the Base, remove the Hex Nut at the top
of the Simmer Ring. Clean the Simmer Ring with hot
soapy water using a soft wire or plastic bristle brush
then dry thoroughly. Re-assemble the parts using the
Hex Nut.
After cleaning, it is important to make sure the
Locating Pin on the bottom side of the Simmer Ring
is properly aligned with the corresponding hole in
the Base and that the Locating Pin (see insert) in the bottom side of the Brass Port Ring is properly
aligned with the Locating Notch on the top side of the Simmer Ring. Incorrect alignment will produce a
potentially dangerous flame and poor burner performance. See the illustration above.
CLEANING THE IGNITERS:
Be certain all burner knobs are in the OFF position before attempting to clean the igniters. Gently
wipe with a water dampened cotton swab and be careful not
to damage the igniter.
Care and Maintenance
10
IGNITER
COOKTOP BURNER
Cap
Brass
Port
Ring
Simmer
Ring
Hex Nut
Base
Brass Port Ring
Locating Pin
Locating Pin
Locating
Notch
Locating
Pin Hole
Inside
Center Burner Base shown