Filter
Top Products
5
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug.
It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National
Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of
electric shock by providing an escape wire for the electric current.
WARNING – Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected
electrical supply. It is recommended that a separate circuit serving only this
appliance be provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded. Should you only have a 2-prong
outlet, have a qualified electrician install a correct wall receptacle.
A 3-prong adapter may be purchased and used temporarily if local codes allow.
Follow package directions.
A short power-supply cord is provided to reduce risk of becoming entangled in or
tripping over a longer cord.
Extension Cord
If it is necessary to use an extension cord, use only a 3-wire extension cord that has
a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on the
microwave oven. The marked rating of the extension cord should be AC 115-
120 volt, 15 amp. or more.
Be careful not to drape the cord over the countertop or table where it can be pulled
on by children or tripped over accidentally.
Notes:
1. If you have any questions about the grounding or electrical instructions, consult
a qualified electrician or service person.
2. Neither DCS nor the dealer can accept any liability for damage to the oven or personal injury resulting from failure
to observe the correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven
is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and
signal of receiving antenna.
C
4"
4"
6"
A
B
(about 100 pounds). The floor should be level for
proper operation of the oven. Be sure to check the
local building code as it may require that the open-
ing be enclosed with sides, ceiling and rear parti-
tion. The proper functioning of the oven does not
require the enclosure.
Call toll-free: 1-888-281-5698 for ordering the kit to be
sent to your address.
The kit includes all the necessary parts and easy-to-
follow instructions for installation as well as location
of the power supply. The MOSTK27 (27") and
MOSTK30 (30") kits include simulated frames, which
match the MO-24SS microwave oven.
The ease of assembly for these kits will allow installa-
tion into an existing wall opening in less than an hour
(if power outlet is already properly located).
All it takes are four steps and a Phillips screw driver.
Outlet should NOT be in the shaded area as indicated.
1. If the dimension of DEPTH (C) is more than 21", the
outlet location may be any area on the rear wall.
2. The floor of the opening should be constructed of
plywood strong enough
to support the weight of
the oven and floor load
Unpacking and Installation Instructions
Grounding Instructions
Untitled-1 6/9/04, 3:13 PM5