DCS RDT-364GL Range User Manual


 
10
BURNER EFFICIENCY AND FLAME CHARACTERISTICS
It is necessary to keep the burner ports and the igniters clean for proper lighting and efficient performance of
the cooktop burners (Fig. 05). The burner flame should burn completely around the burner with no excessive
noise or lifting. The flame should be blue in color and stable
with no yellow tips. An improper air-gas mixture may cause
either a burner flutter or a yellow tipped flame. During initial
use, foreign particles in the gas line, or dust in the air around
the appliance may cause an orange flame. This will disappear
with use.
FLAME HEIGHT
The correct height of the flame mainly depends on the size of
the bottom of the cooking utensil, the material of the cooking
utensil, the amount and type of food and the amount of
liquid in the utensil. Following are some basic rules for
selecting flame height.
For safety reasons the flame must never extend beyond the
bottom of the cooking utensil. Never allow flames to curl up
the side of the pan (see Fig. 06). This will discolor or damage
the utensil.
Utensils which conduct heat slowly (such as glass-ceramic) should be used with medium to low flame. If you
are cooking with a large amount of liquid, a slightly larger flame can be used.
COOKTOP BURNERS
The cooktop burners must be kept clean. Cleaning of the cooktop burners should include the igniter. The
cooktop burners have an infinite number of heat settings and there are no fixed positions on the control knobs
between HI and LO. To turn the cooktop burner on, push in on the control knob and turn it counterclockwise
to the “LITE” position. An audible clicking sound will be heard. When the gas has been ignited by the
electronic spark igniter, turn the knob to the desired setting. (The clicking sound should stop as soon as the
burner is lit).
WARNING!
When turning on any cooktop burner, be sure to stop at the “LITE”position before turning the burner to a flame
setting for cooking. If the burner is not lit and it is turned beyond the “LITE”position, to HI, MEDIUM, or LO, there
could be a burst of flame when the burner does light.
COOKTOP USE
PROPER FLAME HEIGHT
Fig. 06
ELECTRONIC IGNITERS
If a burner does not ignite, listen for the clicking sound. If the igniter is not
clicking, TURN OFF THE BURNER. Check the circuit breaker for a blown fuse
or a tripped circuit breaker. If the igniter still fails to operate, see page 34,
“Before Calling For Service”. To light the burner manually, see page 29,
“Power Failure”.
NOTE:
If you are using propane gas, a slight pop or flash may occur at the burner
ports a few seconds after the burner has been turned “off”. This “extinction
pop” is normal for propane gas.
Fig. 05
IGNITER (KEEP CLEAN)