Defy Appliances 731 MF Cooktop User Manual


 
PAGE 13 OF 20
Plate controls
Select the heat level by turning the relevant plate control knob to the required setting.
The higher the number selected, the hotter the temperature of the plate will be.
The plate indicator light will glow when a plate is switched on.
Red dot plates
Plates featuring a red dot in the centre are high speed, high wattage plates for increased
performance.
For your safety these plates are fitted with thermal limiters. Should a plate be
accidentally switched on and left unattended, the limiter will reduce the power output of
the plate and minimise the risk of overheating and the possibility of fire.
Caring for Solid Plates
Before using the plates for the first time, switch them on for about 4 minutes at the
highest setting. This allows the factory applied protective coating to burn in.
To prevent blotchy discolouration and corrosion, moisture from spatters and spills
should be cleaned off immediately.
To clean the plates, wipe them with a damp cloth or nylon pad.
A little liquid detergent may be used.
Do not use metal scourers or sharp metal objects to clean the plates.
After cleaning, dry the plates by switching them on for a short while.
To prevent rust, periodically apply some sewing machine oil or electrical hotplate polish
available from Defy Service Centres.
Extra attention is required in areas of high humidity or in close proximity to the sea.
Recommendations
Use only pots with a solid level base. An uneven base can prolong cooking times and
waste energy.
Use pots with a base diameter slightly larger than the plate. This will ensure even heat
distribution and prevent spillage from dripping onto and staining the hot plate.
Always cover the pot with a lid. This will conserve energy and minimise spillage.
Thermal shock could damage the plates. Do not put cold pots on very hot plates.
Solid plates (Models 731MF and 831MF)
NOTE: THE WARRANTY DOES NOT COVER THE REPLACEMENT
OR REPAIR OF RUSTED OR CORRODED PLATES.