Filter
Top Products
PAGE 5 OF 12
VERY IMPORTANT SAFETY INSTRUCTION
Safety installation for hob with control panel
• A removable horizontal board must be fitted below the hob and 75mm away from the worktop
bottom face.
• Space between this board and the hob must be empty and no objects may be stored or kept there.
• This board will effectively shield the user from the base of the hob which gets hot during use.
The board needs to be removable for service purposes as the hob, once installed, can only be
loosened from below.
• If the hob is installed with a side adjacent to a vertical kitchen cabinet, the distance between the
edge of the hob and that of the cabinet side must be a least 150mm. The distance between the back
wall and the rear edge of the hob must be at least 55mm.
!
Electrical installation
This appliance must be earthed and the manufacturer and the seller do not accept
responsibility for any damage due to incorrect installation or electrical connection.
Earth leakage
This hob should not be connected through an earth leakage system. Refer to S.A.N.S. 10142
Connection to the power supply must be carried out by a licensed electrician, who will ensure
that the hob is correctly connected and safely earthed. The rated current is printed on the serial number
label attached to the base cover. The hob must be connected to the mains through a double pole
isolating switch which has a minimum clearance between the contacts of 3 mm. in both poles. A
means for disconnection must be provided in the fixed wiring.
Note:
The appliance is not intended to be operated by means of an external timer or separate remote-control
system.
Please see the section pertaining to electrical connection as described in the hob manual.