Filter
Top Products
24
The +30sec function allows the oven to being cooking immediately on full power.
The +30secbutton has been pre-programmed to increase in increments of 30 seconds up to a maximum time of 5 minutes.
+30sec
1. Press START/+30secbutton.
The oven will be “: 30” is displayed. M/Windicator lights.
And the oven will start immediately. No need to press START/+30sec button.
The oven light comes on and the turn table starts rotaing and the time in the
display will count down in seconds.
1. Open the door.
• Oven stops operating.
• You can restart the oven by closing the door and touching START/+30secbutton.
2. Press the STOP/Clearbutton.
• Oven stops operating.
• If you wish to cancel the cooking settings, press the STOP/Clear button again.
TO STOP THE OVEN WHILE THE OVEN IS OPERATING
If you see arcing, press STOP/Clear button and correct the problem.
Arcing is the microwave term for sparks in the oven. Arcing is caused by:
a) Metal or foil touching the side of the oven.
b) Foil not molded to food (upturned edges act like antennas).
c) Metal, such as twist-ties, poultry pins, or gold rimmed dishes, in the microwave.
d) Recycled paper towels containing small metal pieces being used in the microwave.
WARNING
ABNORMAL MESSAGE
• If the inside temperature of the oven is higher than expected or the
temperature sensor doesn't work properly, “Err 2” message will be
shown in the display.
• Unplug the power and call our technical service.
• When the temperature sensor is disconnected, “Err 3” message
will be shown in the display.
• Unplug the power and call our technical service.
This function is used for saving energy.
STAND-BY POWER "0"
To set Stand-by power "0" mode
1. Push the STOP/CLEARbutton.
“: 0” appears in the display.
2. Press and hold the STOP/CLEARbutton until display is turned off.
3. To cancel the stand-by power "0" mode, press and hold ZERO ON button until
display is turned on.
The oven is again available for normal use.