Filter
Top Products
CANOPY TYPE
CUPBOARD INSTALLATION
With this type of installation, (and if the rear vent is not used), the venting hole at the
top of the unit must be clear.
Remove the perforated plate underneath the unit by loosening the knurled-headed
screws on either side.
Drill four suitably spaced 5mm. diameter holes through the top of the Cooker hood.
Use these holes as a template to mark the bottom of the cupboard.
Drill four holes of 5mm diameter through the bottom of the cupboard.
Cut a hole in the in the bottom of the cupboard for the power cord to pass through.
Attach the unit to the cupboard using four 25mm long M4 screws and nuts.
Replace the perforated plate.
Plug into a 220V 50Hz earthed wall socket.
The Cooker hood is now ready for use.