Filter
Top Products
WALL MOUNTING
Remove the filters so that the interior of the cooker hood and the
keyhole slots are exposed.
Hold the cooker hood in position against the wall and with a pencil
mark out the location of the keyhole slots on the wall.
Using a masonry bit, drill a hole at the top of each marked slot.
Insert a rawl plug into each hole.
Using pan-head screws with a head diameter slightly smaller than the
bottom opening of the keyhole slot, insert the screws part way into the
rawl plugs.
Leave about 5 mm of the screws proud of the wall to clear the locking
tabs
5 mm
WALL
Position the keyhole slots over the screw heads and hang the cooker
hood from the screws
Tighten the screws.
To prevent the accidental lifting of the cooker hood, flatten the upright
locking tabs, adjacent to each slot.
This will prevent the cooker hood from being accidentally bumped off
the screws.