Filter
Top Products
17
Please note!
Iftheinfuserisdiculttoinsert,beforeinsertion,adaptitto
the right size by pressing the two levers shown in the gure.
7. Once inserted, make sure the two red buttons have
snapped out.
PUSH
8. Close the infuser door.
9. Replace the water tank.
Cleaning the milk container
Clean the milk container each time
you prepare milk as described
below:
1. Remove the lid.
2. Remove the milk spout and
intake tube.
3. Turn the froth adjustment
dial clockwise to the “INSERT”
position (see gure) and pull
o upwards
4. Wash all the components
thoroughly with hot water
and mild washing-up liquid.
All components are dishwash-
er safe, placing them in the
top basket of the dishwasher.
Make sure there are no milk
residues on the hollow and
groove under the dial (see
gure alongside). If neces-
sary, scrape the groove with a
toothpick.
5. Rinse inside the froth adjust-
ment dial seat with running
water (see gure)
6. Check that the intake tube
and spout are not clogged
with milk residues.
7. Replace the dial (in
correspondence to the word
“INSERT”), spout and milk
intake tube.
8. Place the lid back on the milk
container.
Cleaning the hot
water/steam nozzle
Each time you prepare
milk, clean the nozzle
with a sponge to remove
milk residues from the
gaskets (see gure
alongside).
DESCALE
Descale the machine when the message “DESCALE” ashes on
the display.
Important!
• Descaler contains acids which may irritate the skin
and eyes. It is vital to follow the manufacturer’s safety
warnings given on the descaler pack and the warnings
relating to the procedure to follow in the event of contact
with the skin and eyes.
• YoushoulduseDe’Longhidescaleronly.Usingunsuitable
descaler and/or performing descaling incorrectly may
result in faults not covered by the manufacturer’s guaran-
tee.
1. Turn the machine on.
2. Press the MENU/ESC button to enter the menu.
3. Press the HOT MILK or LATTE button until “Descale” is
displayed.
4. Select by pressing the . button: “Descale Con-
rm?” is displayed. Press again to enable the
function.
5. The message “Add descaler Conrm?” is displayed, alter-
nating with “EMPTY THE DRIP TRAY” and “REMOVE FILTER”
(if the lter is present).
6. Completely empty the water tank (A17) and remove the
water lter (if present). Empty the drip tray (g. 26) and
grounds container, then put back in the appliance.
7. Pour the descaler into the tank up to the level A (corre-
sponding to a 100 ml pack) marked on the side of the tank
(g. 32), then add water (one litre) up to level B (g. 32).
replace the water tank.
Large lever
Small lever