Filter
Top Products
8
ቢ
LEVELLING THE RANGE
The range is equipped with 4 LEVELLING FEET (supplied in a separate kit) and may be
levelled by screwing or unscrewing the feet (fig. 1.8).
It is important to observe
the directions of figures 1.6, 1.7a, 1.7b.
+ 5/16"
+ 8 mm
+ 5/16"
+ 8 mm
0 mm
0"
+ 11/16"
+ 17.5 mm
Fig. 1.6
Fig. 1.7a Fig. 1.7b
Fig. 1.8
ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS
1. The anti-tip bracket has to be attached as shown on figure below (only rear left side),
it has to be fixed on the floor and on the rear wall by no. 4 (four) suitable screws (not
supplied).
2. After fixing the anti-tip bracket, slide range into place. Be sure the rear left foot slides
under the anti-tip bracket attached.
=
=
(223 m
m
)
8" 25/32
Dotted line showing the position
of the range when installed
ANTI-TIP STABILITY
DEVICE FIXING
Rear left
feet of range
Fig. 1.9
Anti-tip stability
device
Supplied with the range
in a separate kit
Supplied with the range
in a separate kit
YOU MUST USE STABILITY
ANTI TIP BRACKET TO
PREVENT UNIT FROM
TIPPING.