Filter
Top Products
9
Description of the accessories
(page 2 - C )
C1. Measure
C2. Cleaning brush
C3. Descaler bottle
C4. Water softener filter (certain models only)
C5. Hot water spout
Description of milk container
(page 2 - D )
D1. Froth adjustment knob
D2. Frothed milk spout (adjustable)
D3. Milk intake tube
D4. CLEAN button
PRELIMINARY CHECKS
Checking the appliance
After removing the packaging, make sure the
product is complete and undamaged and that all
accessories are present.
Do not use the appliance if it is visibly damaged.
Contact De’Longhi Customer Services.
Installing the appliance
Important!
When installing the appliance, respect the fol-
lowing safety warnings:
-
ning the appliance on the worktop, leave a
space of at least 3 cm between the surfaces
of the appliance and the side and rear walls
and at least 15 cm above the coffee maker.
cause damage. Do not place the appliance
near taps or sinks.
it contains freezes. Do not install the applian-
ce in a room where the temperature could
drop below freezing point.
cannot be damaged by sharp edges or con-
tact with hot surfaces (e.g. electric hot pla-
tes).
Connecting the appliance
Important!
Check that the mains power supply voltage cor-
responds to the value indicated on the rating pla-
te on the bottom of the appliance.
Connect the appliance to an efficiently earthed
and correctly installed socket with a minimum
current rating of 10A only.
If the power socket does not match the plug on
the appliance, have the socket replaced with a
suitable type by a qualified professional.
Using the appliance for the first time
Please note!
-
pliance and it is therefore completely normal
for there to be traces of coffee in the mill. The
machine is, however, guaranteed to be new.
soon as possible following the instructions
in the section “Setting water hardness” on
page 19.
1. Plug the appliance into the mains socket and
make sure the main switch on the back of the
appliance is in the I position (fig. 1).
You must first choose the language (the langua-
ges scroll through at intervals of about 3 secon-
ds).
2. When “English” appears, press the but-
ton (fig. 2) for a few seconds until “ENGLISH
installed” is displayed.
Follow the instructions displayed by the applian-
ce:
the MAX line with fresh water (fig. 3A) then
replace in the appliance (fig. 3B).
hot water spout is inserted on the nozzle and
place a container with a minimum capacity of
100 ml underneath (fig. 4).
5. “Hot water... Confirm?” is displayed;
6. Press the button to confirm. The ap-
pliance delivers water from the spout then
goes off automatically.
The coffee maker is now ready for normal use.
Please note!
you need to make 4-5 cups of coffee or 4-5
cappuccinos before the appliance starts to
give satisfactory results.
is normal to hear the noise of boiling water.
After this, the noise diminishes.