Filter
Top Products
10
Fig. 16 Fig. 17
Fig. 19
A
D
B
F
A
J
Fig. 18
Fig. 20 Fig. 21
4. If an adjustment is necessary, loosen two screws (F)
Fig. 17, and adjust splitter bracket (A) until it is aligned
with the inside blade flange (B) Fig. 15. Tighten two
screws (F). Loosely assemble screw and fastener plate
(C), which were removed in STEP 3.
5. Insert threaded end of support rod (G) Fig. 18,
through slot in rear of saw and into hole in rear trunnion
(H). Fasten support rod (G) to trunnion with star washer
and hex nut (J) Fig. 19. NOTE: Thread nut (J) Fig. 19, onto
threads of support rod (G) as much as possible by hand.
6. Using a wrench to hold the hex nut (J) Fig. 19, tight-
en rod (G) Fig. 20, with a small screwdriver (K) or similar
device through the hole in the end of the rod as shown in
Figure 20.
7. Assemble lower bracket (L) Fig. 21, to rod (G) and
loosely tighten with two 5/16-18x1" hex head screws (S)
and 5/16" lockwashers from underneath bracket (L).
G
H
G
K
S
L
G