Filter
Top Products
112127-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
16
INSTALLING OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL ACCESSORIES -
GHRCB AND GHRCTB SERIES
Installing Remote Receiver
1. Open bottom door on stove body.
2. Disconnect wires from THTP and TH on control valve that
lead to the switch (see Figure 33, page 15). Discard switch
plate, screws, and nuts.
3. Install battery into receiver battery clip and connect to terminals
(see Figure 36).
4. Place receiver into valve bracket and align holes (see Figure 37).
5. Use push-in fasteners included with receiver to secure to
bracket.
6. Connect the wires from the receiver to the valve at TH and
THTP (see Figure 33, page 15).
Figure 36 - Installing Battery in Receiver
9-Volt
Battery
Receiver
Battery Clip
Terminal
Wires
TPTH TP TH
TPTH TP TH
Figure 37 - Installing Remote Receiver
WARNING: Do not connect this thermostat to a
power source. Electrical shock and/or fire hazard
will occur.
4. Route the wire to a convenient location to mount your thermo-
stat (no outside wall).
IMPORTANT:
The wire must not ex-
ceed 25 feet in length.
The thermostat should be mounted 54" above the floor in a
location where there is good air circulation. Avoid heat sources
such as lamps, direct sunlight, fireplace, or heat and air con-
ditioning ducts.
5. Gently remove the cover of the thermostat from the base. Grasp
the sides of the cover firmly and pull to separate from the base.
6. Feed the electrical wires through the rectangular slots (from
the back) on each side of the base (see Figure 34).
7. Connect one bare wire end to each terminal (“W” and “R”) of
the thermostat base (see Figure 35).
8. Install the base to the wall with screws provided with thermostat.
9. Move the temperature adjustment back and forth to insure the
bi-metal is free from restrictions.
Figure 34 - Back View of
Thermostat Base
Feed wires through
rectangular slots
Figure 35 - Thermostat
Base Terminal “W” and “R”
W
R
Terminal
“W”
Terminal
“R”
CAST IRON STOVE AND
B-VENT BURNER SYSTEM
INSTALLATION
Continued
CAST IRON STOVE AND B-VENT BURNER SYSTEM INSTALLATION
Installing Optional Wall Mounted Thermostat - GWMT1 (Cont.)
Installing Optional Wireless Hand-Held Remote Control Accessories - GHRCB and GHRCTB Series