Filter
Top Products
112127-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
17
17
Figure 38 - Installing Battery in Hand-Held Remote Control Unit
(GHRCB Only)
Installing 9-Volt Battery in Hand-Held Remote
Control Unit
1. Remove battery cover on back of remote control unit
2. Attach terminal wires to a 9-volt battery (not included). Place
battery into the battery housing.
3. Replace battery cover onto remote control unit.
Terminal Wires
Battery Cover
9-Volt
Battery
Remote
Control
Unit
Battery Housing
CAST IRON STOVE AND
B-VENT BURNER SYSTEM
INSTALLATION
Continued
Figure 39 - Installing Battery in Hand-Held Remote Control Unit
(GHRCTB Only)
Terminal Wires
Battery Cover
9-Volt
Battery
Remote
Control Unit
Battery
Housing
CAUTION: Do not operate this burner system with
a broken glass door panel or without the glass door
panel securely in place. For replacement part infor-
mation see
Replacement Parts
, page 26.
1. If stove front panel is still installed, remove 2 bolts from bot-
tom of stove and one from the top of stove to remove front panel
(see Figure 40). For the Oxford stove the middle grate will
need to be removed to remove the top bolt.
2. Remove the screws from the 2 tabs at the top of the glass door
while holding door securely keeping it from falling forward
(see Figure 41).
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install logs, lava rock, and ember
material. To remove glass door, you must first remove the front
panel on stove body.
Figure 41 - Removing Glass Door from Burner System
Figure 40 - Removing Front Panel from Stove (Oxford™ Model
Shown)
Screw
Glass Door
Bolt
Bolt
Stove Front
Panel
3. Grasp door by both sides and ease it upward off of the lower
bracket (see Figure 41).
4. To replace glass door, follow the above instructions in reverse.
CAST IRON STOVE AND B-VENT BURNER SYSTEM INSTALLATION
Installing Optional Wireless Hand-Held Remote Control Accessories - GHRCB and GHRCTB Series (Cont.)
Removing/Replacing Glass Door
Middle
Grate