Filter
Top Products
112127-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
8
INSTALLING REAR COVER
1. Place rear cover behind stove body. Rear cover will rest on the
bottom ledge of the stove body.
2. Using hex screws provided, attach rear cover to back of stove
body. See Figure 19.
IMPORTANT:
This rear cover must be
securely in place before venting pipes are installed.
3. Open lower door panel. The valve is attached to the underside
of the burner system assembly.
4. Connect or reconnect gas supply, see Connecting Stove/Burner
System to Gas Supply on page 14.
Figure 19 - Installing Rear Cover (Shown with Optional Blower
Accessory)
Rear Cover
(Shown with
Optional
Blower)
Hex Screws
Blower Power Cord
5. Place speed control on left inside of rear cover and push the
plastic control shaft through opening (see Figure 17, page 7).
6. While supporting speed control, secure control shaft with lock
nut by pushing and turning lock nut with pliers clockwise until
tight against the side of rear cover. Place control knob provided
onto shaft.
7. Place the green ground wire between the bottom hole on the
blower assembly and the hex screw and tighten (see Figure 18).
8. Connect the blue wire on the blower assembly to one side of
the thermal switch (see Figure 18).
9. Connect the black wire to the other side of the thermal switch
(see Figure 18).
10. Connect the white wire to the other terminal on the blower mo-
tor assembly (see Figure 18). Make sure the thermal switch has
been properly installed to fit against back of burner system in-
sert after the rear cover assembly has been reinstalled.
11. Make sure all wire connections to terminals on blower motor
and thermal switch are securely attached and that the screw
retaining the green ground wire is tight.
12. Check to make sure that the power cord is completely clear of the
blower wheel and that there are no foreign objects in blower wheel.
WARNING: Never touch the blower wheel while in
operation.
WARNING: Failure to position the parts in accor-
dance with supplied diagrams or failure to use only
parts specifically approved with this heater may result
in damage or personal injury.
WARNING: A qualified installer or service person
must connect burner system to gas supply. Follow all
local codes.
Figure 18 - Blower Wiring Layout
13. Peel off the backing paper and stick the supplied wiring dia-
gram decal on the inside of rear cover as shown (see Figure 18).
14. Reattach bottom cover to rear cover with 8 screws (see Figure
16, page 7). Make sure that you don’t pinch any wires during
reassembly. Route power cord through plastic bushing in bot-
tom of rear cover.
CAST IRON STOVE AND B-VENT
BURNER SYSTEM ASSEMBLY
Continued
Green Ground Wire
Wiring
Diagram
Decal
Speed
Control
Black
Wire
White
Wire
Blue Wire
Power Cord (Route Through
Plastic Bushing in Bottom
Cover When Assembled)
Screw
Thermal
Switch
CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY
Installing Optional Blower Accessory (Cont.)
Installing Rear Cover