Filter
Top Products
20
A-DV54
EN
cleAning
inTelliPaP CleaninG
WARNING
To avoid electric shock, always unplug the power cord from the wall outlet
power source before cleaning.
CAUTION– Never rinse or place the device in water. Never allow liquids to get into or around
any of the ports, switches or air filter; doing so will result in product damage. If this
occurs, do not use the device. Contact your home care provider for service.
Device Cabinet
1. Unplug the IntelliPAP from the power source. Wipe the enclosure with a clean, damp
cloth every few days to keep the enclosure dust free.
2. Allow the device to dry completely before plugging it into a power source.
Filters
Air-Inlet Filter (Standard)
1. The air-inlet filter should be checked every 10 days and cleaned as necessary. The filter
is located in the rear of the device.
CAUTION– Proper filter function is important for the operation of the device and to protect the
device from damage.
2. To clean, remove the dark outer foam filter from the frame.
3. Wash the filter in a solution of warm water and dishwashing detergent, and rinse with
water. Allow the filter to dry completely. If the filter (part #DV51D-602) is damaged,
contact your home care provider for a replacement.
4. Ensure the filter is completely dry before installation and use.
Fine Particle Filter (Optional)
1. If you have an optional fine particle filter (part #DV51D-603), inspect this filter and
replace it if it shows signs of dirt or damage. Do not wash.
2. Install the fine particle filter behind the standard filter.
NOTE– If the fine particle filter is not installed first according to the directions, the life of the filter will be
reduced requiring more frequent replacement.
Tubing
The air supply tubing should be cleaned daily. Remove the tubing from the device and mask.
Use a mild detergent and water to clean the inside of the tubing. Rinse the tubing and allow
to air dry.
Mask and Headgear
Clean the mask and headgear according to the manufacturer’s instructions.