Filter
Top Products
6
SECURING THE REFRIGERATOR
seal at the front frame), the refrigerator is to be secured in the
Please note that failure to follow the sequence in securing the
refrigerator in the enclosure can cause leakage between the
frame and cabinet. Any space between the counter, storage
area or ceiling and top of the refrigerator greater than 40
mm should be blocked. The heat produced at the rear of the
refrigerator will become trapped in this space, making the
refrigerator.
The screws have to be installed in the following order:
Two screws installed through the front base and
installation of the lower front strip.
attached after the refrigerator is set into the cut-
out opening. Install the lower front strip by slid-
plate can be on the right or left side depending on
the door swing.)
Once the lower front strip is slipped under the
hinge, the part is possible to swing into place.
Secure the refrigerator and the lower front strip
with two screws: One screw through the hinge,
and on the opposite side one screw through the
lower front strip.
1.
-
-
-
INSTALLATION INSTRUCTIONS
Two screws installed in the top frame.
Remove the top decoration panel.
Open the door.
Gently push the tabs out of
the hole in the hinge with
Carefully tilt the top
decoration panel and lift
to remove from the top
frame.
are accessible from underneath).
Seal the opening for the screws with aluminium
tape.
Replace the top decoration panel. Make sure the
tabs snap back into the holes in the hinge plate.
Two screws installed in the rear base.
2.
-
-
-
-
-
-
-
3.
1
2