Filter
Top Products
8
12 V DC connection
The connection is made to the terminal block marked
back of the refrigerator cabinet.
The refrigerator must be connected to the battery circuit with
two wires of adequate capacity to avoid voltage drop. The
wire gauge should be chosen with consideration to the wire
length in accordance with the table below.
a fuse rated at 20 amps. Correct polarity must be observed
chassis or vehicle frame as one of the conductors. Connect
-
The connections must be clean, tight and free from corrosion.
If not, a resulting voltage drop will cause a decreased cooling
capacity.
Note!
-
ing element can discharge a battery in a very short time. The
relay to be installed on the tow vehicle or in the caravan. The
refrigerator when the ignition is turned off.
CHANGING DOOR SWING
The refrigerator is equipped with a reversible door. A special
door reversing kit must be used to reverse the door. For fur-
ther information, please contact your dealer.
MOUNTING THE DOOR PANEL
The refrigerator is normally delivered without door panel
Before starting the mounting work, read this instruction thor-
oughly and check that the panel dimensions are in compli-
ance with those given in the following table:
PANEL DIMENSIONS
Max thickness 4 mm
Height Width
RM2453 827 825 527 524
RM2553 983 981 527 524
To mount the door panel - with screws
Open the door 90 degrees.
Remove the door decoration
Insert the vertical edges into
the grooves of the door
Push the panel downward
so that the lower horizontal edge
Put the decoration strip across
the door so that the gap is
covered.
Secure the decoration strip
with the three screws removed
in step 2.
1.
2.
3.
4.
5.
6.
Battery
Refrigerator
Switch key
Relay
Breaker
point
Ignition
coil
MAXIMUM CONDUCTOR WIRE LENGTH
Wire length Min. wire size
5 m 4 mm
2
8 m 6 mm
2
INSTALLATION INSTRUCTIONS
1
1
1
1
1
1
2
3
3
4
5