Dometic RMD 8551 Refrigerator User Manual


 
15
The refrigerator must be installed draught-proof
in a recess (also refer to Section "4.1.3"). The
measurements of the recess are stated in the
table below. Push the appliance far enough into
the recess until the front edge of the refrigerator
casing is aligned with the front of the recess.
Allow a gap of 15-20 mm between the back wall
of the recess and the refrigeration unit. The floor
of the recess must be level, allowing the appli-
ance to be pushed easily into its correct positi-
on. The floor must be substantial enough to
bear the weight of the appliance. Ensure that
the refrigerator is installed level in the
recess.
4.5 Installation recess
Installation
Height H Width B DepthT
Models
RMD 8501
RMD 8505
RMD 8551
RMD 8555
1249 mm
529 mm 599 mm
4.5.1 Recess dimensions
After the refrigerator is put in its final place,
secure the screws into the wall of the recess.The
screws must penetrate the casing of the refrige−
rator.
Fig. 27
Fig. 28
In the sidewalls of the refrigerator, there are four
plastic sleeves for securing the refrigerator. The
sidewalls or strips attached for securing the
refrigerator must be prepared to hold the screws
firmly in place even when under increased load
(while the vehicle is moving). Fastening screws
and caps are supplied with the refrigerator.
4.6 Securing the refrigerator
Always insert screws through the sleeves
provided as otherwise components laid in
foam, such as cables etc., could be dama−
ged.
CAUTION!