Filter
Top Products
•
TToo cclleeaann tthhee ccoonnvveeyyoorr bbeelltt::
set the
power saver in the FULL POWER
position, turn the top and bottom
heat control to the OFF position.
For a lightly soiled conveyor belt, turn
conveyor speed control to the slowest
setting (2) and wipe with a damp
cloth.
For a heavily soiled conveyor belt,
turn conveyor speed control to
slowest setting (2) and wipe with a
dry, light abrasive pad.
• After the unit cools, disconnect unit
from power, remove interior crumb
tray and clean. Slide crumb tray back
into position after cleaning.
• Wipe exterior surface of unit using a
damp cloth once the machine has
cooled.
• Never allow a build up of crumbs
in the tray as this may cause fire.
Clean on a daily basis.
• Ensure the cooling fan is clear of dust
and grease.
CCLLEEAANN WWEEEEKKLLEEYY
.
Your Dualit conveyor toaster is equipped
with an automatically activated heat limit
switch that interrupts the heater tube
connections if the ambient temperature in
the control box exceeds 190°F (88°C).
This switch can be reset manually by
pushing the red button on the bottom of
the toaster.
CAUTION: DO NOT OPERATE UNIT
WITHOUT CRUMB TRAY IN PLACE. THE
UNIT WILL OVERHEAT AND ACTIVATE
THE HEAT LIMIT SWITCH.
1. My toast is unevenly toasted?
aa))
Ensure that heat regulators are set to
the highest setting possible and the
switch cannot turn any further. Any
adjustment to the heat settings will take
time to settle and as such these controls
should
nnoott
be adjusted whilst making
toast.
For best results set the heat regulators
both to full, and the speed to 5. Vary the
speed to achieve desired brownness.
HEAT LIMIT SWITCH (RESET)CLEANING PROCEDURES
4
2. My toast is burning or is
underdone?
a) The speed setting should be set at the
half way mark; this can be adjusted to
taste, and will take a matter of seconds to
settle.
If toasting is too light, turn conveyor
speed control counter-clockwise to a
lower speed
If toasting is too dark, turn conveyor
speed control clockwise to a faster speed
b) Allow at least 10 minutes for the
conveyor to heat up and settle from
switch on.
c) If the toaster has been left on full
power without bread passing through it,
the first slices through will burn due to
the build up of heat. When the toaster is
in an idle period it is advised that the
toaster be turned to the ¼ power setting.
This will prolong the life span of the
elements and reduce the chances of
un-even toasting when used again after
the idle period.
TROUBLESHOOTING
TROUBLESHOOTING