Electrolux 241940002 Refrigerator User Manual


 
28
Changing The Water and Air Filters
Your refrigerator is equipped with separate water and
air ltering systems. The water lter system lters all
dispensed drinking water, as well as the water used to
produce ice. The air lter removes odors and impurities
from the refrigerator compartment.
Push Water Filter Button
NOTE
The control panel includes controls to monitor the
status of your water and air lters. See the Controls
section for more information.
About your advanced water lter
The PureAdvantage
TM
ice and water
lter system is tested and certied
by NSF International, the nationally
respected, not-for-prot certication
organization for public health safety. The
PureAdvantage
TM
ice and water lter system is tested
ANDCERTIlEDTO!.3).3&3TANDARDSANDFOR
the reduction of claims specied on the performance
data sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system. Systems certied for cyst
reduction may be used on disinfected waters that may
contain lterable cysts.
s 2ATED#APACITYGALLONSFOR
PureAdvantage
TM
ice and water lter
s 2ATEDSERVICEmOWGALLONSPERMINUTE
s -AXIMUM2ATED0RESSUREPOUNDSPER
square inch
s 2ECOMMENDED-INIMUM/PERATING0RESSURE
30 pounds per square inch
s /PERATING4EMP-IN&-AX&
Water lter
The water lter is located at the lower left side of the
fresh food compartment.
Replacing your PureAdvantage
TM
water
lter
In general, you should change the water lter every
six (6) months to ensure the highest possible water
quality. The Water Filter Status light on the Touch
Panel prompts you to replace the lter after a standard
amount of water (400 gallons)
has owed through the
system.
If your refrigerator has not been used for a period of
time (during moving for example), change the lter
before reinstalling the refrigerator.
It is not necessary to turn the water supply off to
change the lter. Be ready to wipe up any small
amounts of water released during the lter replacement.
1 Turn Off the ice maker on the control panel.
2 Push the lter release button above the cartridge
to disconnect it.
3 Slide the old water lter cartridge straight out of
the housing and discard it.
4 Unpack the new lter cartridge and remove the
two (2) protective caps covering the inlet and exit
of the lter. Slide the lter gently into the housing
until it stops against the snap-in connector at the
back of the housing.