Filter
Top Products
8
Getting Started
BEFORE SETTING OVEN CONTROLS
Removing and Replacing Oven
Racks
ALWAYS ARRANGE OVEN
RACKS WHEN THE OVEN IS COOL
(PRIOR TO OPERATING THE OVEN).
Always use oven mitts when using the
oven.
To remove an oven rack, pull the rack
forward. Lift up the rack off the oven
rack slider. To replace an oven rack,
place the rack on the slider and fit the
sliders pin into the pinhole located at
the 2 front corner of the rack.
1
2
3
4
5
6
7
Rack positions
Arranging Oven Racks
ALWAYS ARRANGE OVEN
RACKS WHEN THE OVEN IS COOL (PRIOR TO
OPERATING THE OVEN).
To bake on a single rack, place the rack in position 3. To bake
on 2 racks, place the racks in position 2 and 7. To bake on 3 racks,
place the racks in position 1, 3 and 7.
RECOMMENDED RACK POSITIONS FOR BROILING,
BAKING & ROASTING
Food Rack Position
Broiling meats, chicken or fish 6 or 7
Cookies, cakes, pies & muffins 5 or 6
Frozen pies, angel food cake, yeast, bread, 2
casseroles, small cuts of meat or poultry
Turkey, roast or ham 1
Note: Always use caution when removing food.
Oven Vent Location
The oven is vented under
upper control panel.
When the oven is on, warm
air is released through the
vent. This venting is
necessary for proper air
circulation in the oven and
good baking results.
Oven Vent
Warm Air
Installing Oven Rack Supports
ALWAYS INSTALL OVEN RACK
SUPPORT BEFORE TURNING ON
THE OVEN (WHEN THE OVEN IS
COOL).
To install oven rack support, insert
the support tabs in the holes located
on the oven inside side as shown
below. To remove the oven rack
support for a self-clean cycle, pull
up the support to disengage the tabs
from the oven. If the rack supports
are not removed, the self-clean cycle
won’t start. Always remove the left
side support first.