Filter
Top Products
19
Setting Surface Controls
OPERATING THE DUAL SURFACE RADIANT ELEMENT
Both the 30” and 36” cooktops are equipped with dual radiant surface element
located as shown in Figs. 1 & 2. A touch key pad on the element controls is
used to select one of the 2 positions of the element. Symbols and indicator
lights on the control panel are used to indicate which coil of the dual radiant
element will heat. The symbol indicates that only the INNER coil will heat
(Fig. 3). The
symbol indicates that both INNER and OUTER coils will heat
(Fig. 4). You may switch from either coil setting at any time during cooking.
!
CACA
CACA
CA
UTIONUTION
UTIONUTION
UTION
Radiant surface elements may appear to have cooled after they have been turned OFF. The Hot
Element (HE) message will be showed and will continue to display until the glass cooktop has cooled
down to a moderate level. The glass surface may still be hot and burns may occur if the glass surface
is touched before the display has turned OFF.
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
POWER
key pad until a beep sounds. The power
indicator light above the
POWER
will turn ON. Note: If no other key pad
is touched within 20 seconds the request to Power ON the cooktop
will clear.
3. Touch and hold the
ON OFF
pad for the dual element position until a beep
is heard. Note: If no further pads are touched within 10 seconds the
request to power the element ON will clear.
4. Select the INNER (Fig. 3) or INNER and OUTER (Fig. 4) to heat by
touching the
size
key pad.
5. Touch pad once to turn ON the power level to HI or touch pad once for
power level to Lo.
6. Each touch of the or pad will increase or decrease the power level. Lo is
the lowest power level available. Note: The power level may be adjusted at any
time while the element is ON.
7. Start most cooking operations on a higher setting and then turn to a lower setting to
finish cooking. Each surface element provides a constant amount of heat at each
setting. A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area.
8. When cooking has been completed touch the
ON OFF
pad once to turn the element OFF
and if no other surface element is used touch the
POWER
key pad to turn off the
cooktop.Note: The Hot Element (HE) message will be showed on display for each
element until the heating surface area has cooled sufficiently.
lo
-
hi
+
lo
-
hi
+
lock
warm
hi
+
lo
-
hi
+
lo
-
timer
POWER
ON OFF
lock
warm
lo
-
hi
+
lo
-
hi
+
lo
-
hi
+
hi
+
lo
-
hi
+
lo
-
timer
POWER
ON OFF ON OFF ON OFF ONOFF ONOFF
Fig. 1
Fig. 3
Fig. 4
Fig. 2