Filter
Top Products
25
What to do if...
Remedying small malfunctions
If the acoustic signal is activated, warning tones sound if there are
faults.
If while the appliance is operating indicators on the control panel flash
or are lit up as described in the following table, please consult this to
find out how to remedy the fault.
After remedying the fault that is flashing in the first or second
rhythm in the programme progress display, press the button for the
dishwashing cycle that had already started. The cycle will continue.
In the case of other fault messages:
– Cancel the dishwashing cycle.
– Switch the appliance off and on again.
– Select dishwashing cycle.
If the fault is displayed again, please contact the Service Force Centre
and inform them of the fault message.
Malfunction Possible cause Remedy
1 short warning tone,
continuously repeated,
can be heard,
the programme display for
the selected wash pro-
gramme is flashing:
the indicator for the end
of the wash programme is
flashing once
continuously .
(problems with water in-
flow).
Tap is blocked with limes-
cale or is faulty.
Check the tap and have it
repaired, if necessary.
The tap is turned off. Turn on the tap.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Cancel the dishwashing cy-
cle (see chapter: Starting a
dishwashing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing
cycle again.
Water inflow hose has not
been correctly positioned.
Check the position of the
hose.