Filter
Top Products
8
2.Press and hold the programme button for approx. 3 seconds.
Programme display 2 will light up and go out after approx. 3 seconds.
The indicator for the programme button will flash.
The indicator for the end of the dishwashing cycle will flash simultane-
ously:
– The number of times that the indicator for the end of the dishwash-
ing cycle flashes corresponds to the hardness setting.
– This sequence of flashes is repeated several times, with a 3 second
pause in between.
3.Pressing the programme button increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
4.When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to “1”, this switches off the
control indicator for special salt.
Water hardness
Adjusting the hardness
setting
Number of
flashes
in °d
1)
1)(°d) German degree, measure of the hardness of water
in mmol/l
2)
2)[mmol/l] millimol per litre, international unit for water hardness
Range Manual Electronic
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
9,0 - 12,5
7,6 - 8,9
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
IV 1
10
3)
9
8
7
6
3)On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
10
9
8
7
6
0*
19 - 22
15 - 18
3,3 - 3,9
2,6 - 3,2
III
5
4*
5
4
11 - 14 1,9 - 2,5 II 3 3
4 - 10 0,7 - 1,8 I/II 2 2
below 4 below 0.7 I
1
no salt
necessary
1