Filter
Top Products
Operating instructions
34
...the wash results are not satisfactory
The dishes are not clean
● The incorrect washing programme has been selected.
● The dishes were arranged in such a way as to stop water reaching all
parts of the surface. The baskets must not be overloaded.
● The spray arms do not rotate freely due to incorrect arrangement of
the load.
● The filters in the base of the washing compartment are dirty or
incorrectly positioned.
● Too little or no detergent has been used.
● Where there are limescale deposits on the dishes; the salt container
is empty or the wrong level of the water softener has been selected.
● The drain hose connection is not correct.
● The salt container cap is not properly closed.
...there are problems when operating the dishwasher
The programme does not
start
Use a different brand of
detergent.
The whistling is not a cause
for concern.
The dishwasher door has not
been properly closed.
Close the door.
The main plug is not plugged
in.
Insert the mains plug.
The fuse has blown in the
household fuse box.
Replace the fuse.
Delay start has been selected. If dishes are to be washed
immediately, cancel the
delay start.
There is a whistling noise
during washing
Fault Possible cause Solutions
Once the checks have been carried out, press the programme
selection/cancel button and close the dishwasher’s door. The
programme will continue from the point at which it was interrupted. If
the fault code reappears contact your local Service Force Centre.
For other combinations of fault codes not described in the above chart
will appear, please contact your local Service Force Centre.
152950 74/0en 2-10-2006 10:25 Pagina 34