Filter
Top Products
Operating Instructions
23
5)
During the AUTOMATIC programmes, the level of soiling of the dishes is determined via the clouding
of the wash water. If the dishes are heavily soiled, the parts of the programme given in brackets are
carried out. If the dishes are lightly soiled, these parts of the programme are skipped. For this reason
the duration of the programme, water and electricity consumption on AUTOMATIC programmes can
vary within the ranges given.
6)
Test programme
Start the wash programme
0 1. Open the door of the dishwasher.
2. Check that when the dishes and cutlery are loaded into the dishwasher
the spray arms are free to rotate.
3. Open the tap fully.
4. Press the ON/OFF button. The indicator in the ON/OFF button illumi-
nates.
5. Press the programme button for the desired programme (see "Pro-
gramme Table"). The programme indicator illuminates.
Have you accidentally selected the wrong wash programme?
• If you want to change the wash programme within 6 seconds of mak-
ing a programme selection, briefly press the button for the new wash
program.
• If you want to change the wash programme at a later point in time,
use the following procedure:
– Press the button for the new wash programme and hold it pressed.
The indicators for both programmes now flash.
– After a few seconds only the indicator for the new programme
flashes. Release the programme button, the new wash programme
has been saved.
6. Close the door. After around 6 seconds the door is automatically locked
and the selected wash programme begins.
3
If acoustic warning tones can be heard after the start of the pro-
gramme, please read the "What to do, if..." section.