Filter
Top Products
Operating Instructions
32
5. Press the relevant button for the cycle required (see ”Cycle Table”).
The selected cycle will begin after approximately 3 seconds.
The function can no longer be changed after the cycle has begun. In
this case the dishwashing cycle must be aborted by pressing RESET, and
must then be reselected.
3
If the additional function has been selected once, it will remain acti-
vated for all subsequent wash cycles unless it is deactivated by pressing
the button again.
3
The cycles lengths given in the cycle table may change if the additional
function is used.
3
When changing from 3-in-1 dishwashing tablets to conventional
detergent please be sure above all to take note of the last 3 points in
the chapter ”Using 3-in-1 dishwashing tablets”.
Setting or changing the start delay
Using the start delay timer you can adjust when within the next 19
hours the programme is to begin.
Setting the start delay:
0 1. Press the ON/OFF button.
2. Continue pressing the DELAY TIMER button until the number of hours
until the start of the programme is flashing in the multi-display.
3. Press the button for the desired programme.
The length of the selected programme will flash for a moment in the
multi-display, and then it will display the selected starting time again.
As soon as the number of hours is displayed without flashing, the start
delay has been activated.
The programme will start automatically following a countdown of the
hours set.
Changing the start delay:
As long as the programme has not started, you can still change the
start delay set by pressing the DELAY TIMER button until the desired
start delay is shown in the multi-display.
Cancelling the start delay:
As long as the programme has not started you are able to cancel the
start delay. Continue pressing the DELAY TIMER button until the length
of the selected programme appears in the multi-display. The selected
programme will start immediately.