Filter
Top Products
8
Prior to Using for the First Time
1.Set the water softener
2.Fill up with dishwasher salt
3.Fill up with rinse aid
3 If you wish to use 3in1 detergent, do the following:
– First read the section “Using 3in1 detergents”.
– Switch on the dishwasher, press the 3in1 button. The button indicator
lights up: 3in1 function is selected. As a result
– there is no need to fill up with dishwasher salt or rinse aid.
– there is no need to set the water softener.
– there is no need to set the rinse aid dispenser.
– Before the start of the dishwashing cycle put 3in1 detergent in the
detergent dispenser.
3 Once this additional function has been selected, it remains activated
for all further dishwashing cycles until it is cancelled by pressing the
button again.
3 The lengths of the wash cycles given in the cycle table can be changed
if this additional function is used.
3 When changing from 3in1 detergent tablets to normal detergent, it is
most important to observe the last 3 points in the section “Using 3in1
detergents”.
Setting the Water Softener
3 To avoid scale deposits on the dishes and in the dishwasher, the dishes
must be washed with soft water, i.e. water with a low lime content. The
water softener must be set according to the table to the water hard-
ness in the area where you live. Your local water company will be able
to give you information about the water hardness in your area.
1.Press the ON/OFF button.
3 If the LED indicator of only one programme button is illuminated, this
wash programme has been activated. The wash programme must be
deselected:
Press function buttons 2 and 3 simultaneously for approx. 2 seconds.
The LED indicators of all the buttons that can be selected will illumi-
nate.
Exception: The 3in1 button will only illuminate if the function has been
activated.