Filter
Top Products
What to do if …22
If you are unable to remedy the problem by following the above sugges
tions, please contact your local Service Force Centre.
1 Warning! Repairs to the appliance are only to be carried out by qualified service
engineers. Considerable danger to the user may result from improper repairs.
3 If the appliance has been operated incorrectly, the visit from the service techni
cian or dealer may not take place free of charge, even during the warranty peri
od.
Display changes between two
heat settings
Power Management is reduc
ing the power of this cooking
zone
See the section “ Switching
the power function on and
off”
Power Management is active,
maximum load per side
reached
Use cooking zones on other
side
f flashes Unsuitable cookware Use suitable cookware
No cookware on the cooking
zone
Put cookware on zone
Diameter of the base of the
cookware is too small for the
cooking zone
Use suitable cookware (min.
120 mm)
Cookware not completely cov
ering cross
Place cookware centrally over
the cross
_ is lit Overheating protection for the
cooking zone has been trig
gered
Switch off the cooking zone.
Switch the cooking zone on
again
Automatic switch off has been
triggered
Switch off the cooking zone.
Switch the cooking zone on
again
e and number are displayed Electronics fault Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house’s wiring system)
If after switching on again,
e
is displayed again, call the cus
tomer service department
e and minus are displayed Light rays that are too strong
on the control panel, for ex
ample bright sunlight
Briefly shade the control pan
el, for example with the hand
Acoustic signal sounds, appli
ance switches itself off Switch
appliance on (again)
Problem Possible cause Remedy