Filter
Top Products
50
What to do if …
Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch the oven on
The clock has not been set Set the current time on the
clock
The required settings have
not been set
Check the settings
The oven’s safety cut-out has
been tripped
See “Safety cut-out”
The fuse in the house’s elec-
trical wiring (fuse box) has
been tripped
Check fuse. If the fuses trip
repeatedly, please call an au-
thorised electrician
The oven lighting is not op-
erating
The oven bulb is faulty Change the oven bulb
Pyroluxe is not working
(“C1” appears in the display)
The oven shelf supports have
not been removed
Remove oven shelf support
The oven door is locked Appliance is not connected
to the electricity; door lock is
activated
Connect the appliance to the
electrical supply and wait at
least 10 seconds until the red
temperature pilot light goes
out
In the clock display you see:
E001
E020 (when operating nor-
mally)
E021
Temperature outside the per-
mitted range
Please contact your local
Service Force Centre.
In the clock display you see:
E020 (when pyroluxe is op-
erating)
Door is not closed properly Close the door properly and
start the pyroluxe again
If displayed again, please
contact your local Service
Force Centre.
In the clock display there ap-
pears a fault code that is not
listed above
Fault in the electronics Switch off the appliance via
the house fuse or the safety
switch in the fuse box and
switch it on again.
If displayed again, please
contact your local Service
Force Centre.